Your garage is probably the most-visited room in the house. Right now it has overhead fluorescents. This kit changes that in an afternoon, 14 aluminum-frame hex panels running full brightness across your garage ceiling, the kind of setup people pull out their phones to photograph when they walk in.
Want brightness control? The dimmable version adds three brightness steps, 100%, 60% and 30%, cycled from the wall switch you already have, for about $100 more.
Lighting more than one bay? The garage bundles pair two, three, four or five of this exact kit at 10% off buying them separately.
This Isn't the Import-Box Version
You've seen cheap hex kits, plastic frames that bow in six months, 2-pin aluminum wire that works loose, and no support after the sale. Here's what you're actually buying when you go SV:
-
Aluminum frames, permanently. No sagging, no warping, no panels slowly pulling away from the ceiling. Aluminum holds its shape at temperature extremes that would ruin plastic.
-
Copper wiring, 3-pin connectors. More conductive than aluminum wiring, and the 3-pin design physically locks, it can't work loose over time the way 2-pin connections do.
-
Fire-resistant connectors. Non-negotiable when you're running electrical overhead.
-
Spare parts in the box, and stocked in-house. If something needs replacing two years from now, we have the part. No hunting a marketplace listing for a close match that isn't.
-
2-year warranty from a real business you can call. We're in DFW. We answer the phone.
Specs
| Panel count |
14 hexagon panels with border frame |
| Assembled size |
15'11" W × 8'0" H (190.53" × 95.78") |
| Lit area |
91 sq ft of lit hexagon |
| Brightness |
~63,500 lumens · 6500K daylight white · CRI ≥90 |
| Frames |
Aluminum, no sag, no warp |
| Wiring |
Copper, 3-pin locking connector |
| Ingress rating |
IP54 |
| Dimming |
Full brightness, fixed (non-dimmable) |
| Install options |
Flush mount (included) or suspended (cable kit) |
| Warranty |
2 years, spare parts included |
| Tolerance |
Assembled sizes are the finished footprint and are accurate to about 2 in. Tube and rail lengths are fixed, so the overall size lands on set increments rather than any dimension you name. |
Power Requirements
| Total draw |
~552W (~5.0A at 110V) |
| Electrical |
Have a licensed electrician confirm the circuit you connect to can carry the load shown above. |
What's in the Box
- 57 LED hex tubes + 12 border rails (pre-configured 14-panel layout)
- All connectors: 120° Y, 2-way, 3-way T, and corner connectors
- Power cables, zip ties, and mounting anchors for flush install
- Spare parts kit
Two Ways to Install, One Upgrade Worth Taking
Only Light, $379.99
Panels sit flush against the ceiling. Clean, tight, no gaps. Takes a few hours to mount and looks sharp immediately. This is the right call for most garages.
Light + Cable Installation Kit, $429.99
34 rust-resistant coated cables, each adjustable up to 36", suspend the panels off the ceiling for a floating, layered look. This is what you see in the highest-end garage builds and recording studios. For $50 more, it adds depth that makes the installation look twice as expensive.
Compare SV Kits
Sizes are finished footprints at the measured hex pitch. Lit area is the lit hexagon area inside that footprint.
